HKPRO Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
I can't tell from the manual, and it seems to fit in both ways. My question is;


Which side of the back end of the rod should mate with the block on the barrel and which one should face up, as if you were holding the slide in your hand upside down???

One side seems to have a more jagged cut in it as opposed to it's opposite...

I hope you guys can understand what I mean.. I had some jamming issues yesterday and though it may be a magazine issue, I want to make sure maybe it wasn't my reassembly the night before.

The fact that the rod holds it's position both ways scares me and I don't want to reassemble until I get some advice...

Thank you.
 

·
Premium Member
Joined
·
293 Posts
When you hold the slide upside down, the round symmetrical cut should be upwards.

I haven´t managed to make it stay in the barrel the other side up. I think you have it on correctly.

Happy holidays!!!

Miku
 

·
Registered
Joined
·
62 Posts
Discussion Starter #3
When you hold the slide upside down, the round symmetrical cut should be upwards.

I haven´t managed to make it stay in the barrel the other side up. I think you have it on correctly.

Happy holidays!!!

Miku
Thank you.. that is the way I had it and I am relived Thank you so much...

And Happy Holidays to you too aand al HK PRO Members!!!
 
1 - 3 of 3 Posts
Top