HKPRO Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
193 Posts
Discussion Starter · #1 ·
Hey all,

Anyone know if a 9mm USP variant with a jet funnel and raised suppressor sights will fit in a Pelican 1170? Going purely based off of imprecise and varying stated dimensions I've found online, it's either barely too big or just barely small enough to fit. Either way it's tight. It'd also be great if someone could post a picture of theirs with a ruler next to it if they're able to or can point to what the exact max height is, preferably in mm or something equally precise.

Standard USP9 Tactical is already a tight fit and it'd be nice to know that it'd still fit in my case with the mag upgrade.

Thanks!
 

·
Registered
Joined
·
193 Posts
Discussion Starter · #3 ·
Ah yeah, forgot they've got the lower sights. So, if anyone's got a USP9 Tactical with jet funnel or knows the accurate exact measurements that'd be great!
 

·
Registered
Joined
·
193 Posts
Discussion Starter · #5 ·
Hopefully with mag inside as well. Measurements both with and without would be super though.
 

·
Registered
Joined
·
193 Posts
Discussion Starter · #9 ·
Alright, thanks! It seems like it should just barely fit with the steel mags loaded, but it will definitely fit without them. Just ordered the kit/mags, will post pics once they get here for anyone else interested.
 

·
Registered
Joined
·
193 Posts
Discussion Starter · #10 ·
Ok, jet funnel arrived. Mags haven't yet but they should be here by the end of the week hopefully. Not sure if they'll clear the clear the case - I'm hoping they will, but it's certainly going to be a tight fit.



 

·
Registered
Joined
·
193 Posts
Discussion Starter · #11 ·
With holidays over, I finally had a bit of time to cut out some foam and mostly finish out the case. I'll probably spray some plastidip onto the foam later for some better heat resistance, otherwise it works very well. It's recessed a little over half an inch in (1.5cm) so it's still easy to grab out but it's very firmly planted in and you can shake the case around without hearing any movement.

The magazine loaded rests against the bottom edge without any pressure on it and the rear sight has a few mm of clearance so it's not got any pressure on it either. All in all I'm very pleased, and if anyone else is wondering, yes the 1170 (barely) works!

 
1 - 6 of 6 Posts
Top