HKPRO Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2,927 Posts
Discussion Starter #1
Is is possible to put a B&T side folding stock on a Vector arms V53LS? Will this affect the functionality of the weapon as far as cycling or no?
 

·
Registered
Joined
·
1,359 Posts
it will fit but i'd advise against it, even B&T says you shouldent do it.

the stock was designed for a 9mm
 

·
Registered
Joined
·
616 Posts
I put one on my vector 33k and the gun refused to work. it would do one shot and the bolt carrier would stick to the rear of the reciever.

at this point I believe it may be due to the reciever being a touch out of spec, and the b&t stock may be a little tight. after I hit the stock with a dremel, im going to try it again.

Im pretty sure it will work fine, but I will be checking it often for signs of premature wear, I was also thinking of epoxying a steel plate into the b&t stock to help disperse the shock of recoil.
 
1 - 4 of 4 Posts
Top