HKPRO Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,785 Posts
Depends on your skill and ability to follow directions. Minimal tools are needed but you do need them. Follow the directions tacked at the top of this forum for a detailed strip and only go as far as you need to go for the replacement of the control lever. Read it and then decide if you have the skills and tools to do it.
To go from V1 to V2 you need a V2 control lever. You cannot simply flip the V1 over and have it work.
 

·
Registered
Joined
·
3,199 Posts
I bought a USP that was V2. I bought the V1 lever and had my local gunsmith (HK armor) swap it out for me. He only charged me $10.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top