HKPRO Forums banner
1 - 20 of 23 Posts

·
Registered
Joined
·
118 Posts
They are known as "charging supports" and HKParts sells them. They are $4.95 each. You can't buy them in pairs.

Link: https://www.hkparts.net/shop/pc/Charging-Support-Right-Side-VP40-367p17685.htm
No, OP asked about the flat filler pieces and you linked to the regular charging supports. This is what he is looking for: https://www.hkparts.net/shop/pc/Cocking-Aid-Filler-Left-Right-Set-VP9-367p17213.htm
For some strange reason, those are more expensive at $17.95 per pair, no idea why.
 

·
Banned
Joined
·
151 Posts

·
Registered
Joined
·
71 Posts
I kind of like the Charging supports, but i guess there's enough milling to not have them.
 

·
Registered
Joined
·
71 Posts
A lot of the students I take out really love the charging supports, and they stand out vs. the other pistols they try of mine.
 

·
Registered
Joined
·
6 Posts
My original inserts got loose and HK installed these free of charge (along with a set of new sights). I wish HK would manufacture the inserts larger than the slots so they didn't move around -- even my new flush inserts have a little bit of play (much less noticeable than the original inserts).
 

·
Registered
Joined
·
93 Posts
My original inserts got loose and HK installed these free of charge (along with a set of new sights). I wish HK would manufacture the inserts larger than the slots so they didn't move around -- even my new flush inserts have a little bit of play (much less noticeable than the original inserts).
weird. mine are ultra tight. wonder if i got lucky?
 

·
Registered
Joined
·
73 Posts
I would not use loctite. Mine have a little up and down vertical play because there is a small gap between the bottom of the meprolight rear sight and the top of the slide where the charge supports fit in. However, it doesn't seem like I could remove them without removing the rear sight.
 
1 - 20 of 23 Posts
Top