HKPRO Forums banner
1 - 5 of 5 Posts

· Registered
10 Posts
Discussion Starter · #1 · (Edited)

I put in a Lazy Wolf Trigger and did some polishing. Put the gun back together, function checked and all.

When i inserted the mag and removed this small block fell out.

I saw another post about this. It was stated that it's a small block which the trigger safety rests on. but I couldn't quite make out the photos of where it goes

What is the exact location for it? Does it need glue back in?

Once I set the overtravel on the trigger the trigger blade worked just fine. Is this not needed?
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.