HKPRO Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,497 Posts
Discussion Starter #1
Does 5.3 inch in length is enough to accommodating most scope mounting situation? I'm thinking to use it on a clone PSG1 build. What will be the optimal location to start if measure from the rear of the receiver? Thanks

HK Picatinny Rail - HKPARTS.NET
 

·
Registered
Joined
·
872 Posts
The longer the better. Which rail system Matt Yehamns - PRI - HKParts? . I have deleted the rear sight base and use a rail. RTG has the take-down sights.

JFK has a build on this site were he shows how he did it.
 

·
Registered
Joined
·
1,497 Posts
Discussion Starter #3
Thanks for the advice I hope Adam can make one is longer. So I check with Jayson at IGF he told me he can weld two together to make it longer.
 
1 - 3 of 3 Posts
Top