HKPRO Forums banner

Weldment insert

657 Views 2 Replies 3 Participants Last post by  gamble
Does anyone make the little welded in reinforcement that is spot welded to 90 series receiver where the mag paddle is ?
1 - 3 of 3 Posts
I'm building my 1st two MP5's. One of the 1st things I noticed when I took the mag release out of the old magwell section is the small reinforcing flats on the inside of the receiver. I bought a small scrap of 16ga sheet metal, made my own pieces and spot welded them into the receiver.
Thous reinforcement tabs are also two different sizes or thickness witch allow the paddle to be centered.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.