HKPRO Forums banner

Who converts your UMP lowers to work on USC?

759 Views 4 Replies 4 Participants Last post by  Max
Hey everyone,

Who do you get to mill the hooks on your UMP lower? Looking to have that done and the selector on a Navy 0,1,F lower work on USC internals.

Give me some names and examples of their work if you can!

Thanks!
1 - 5 of 5 Posts

· Registered
Joined
·
225 Posts
Discussion Starter · #3 ·
Ehhh.... Not too keen on doing things myself. I tend to spend more money sending it off to be fixed after the fact. Like the time I tried to bed my R700 on my McMillan stock! Realized after the fact that I dont have a mill to clean it up hehehe
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top