HKPRO Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Wanting to find either source for original tooling / fixtures that HK would use during mp5 barrel removal or HK german blue prints of such. Also, anyone who has been doing this on expensive factory HKs and has advice for the type of presses , and receiver support that one should use. Don't have the gun in front of me at the moment but do remember that the retaining pin in the trunion should be able to be driven out , maybe need to use an end mill if it's bratted out on the end, and then the barrel is pressed out. Any source or info appreciated.
 
1 - 1 of 1 Posts
Top