HKPRO Forums banner
1 - 3 of 3 Posts

· Registered
1,105 Posts
Discussion Starter · #1 ·
Hello, I am in the process of having an MSG90 and SG1 clone built. I need a rifle case that is large enough to ship both rifles without scopes mounted.

My plan is to ship all the parts to the builder in the case and have the finished rifles shipped back in the same case.

I then want to mount the scope on the MSG90 clone and cut the foam in the case for the MSG90 with scope. I will be purchasing one of the SG1 rifle cases for the SG1 clone.

Basically I think I need a case with the inner dimensions of 50" L x 14" W x 6" deep with two layers of foam on the bottom. I have been looking at a Storm case. Does this sound good? What are your recommendations?

Thanks, :D
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.