HKPRO Forums banner

1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
I have a 91 that I want to use my sear in. Is all I need to change the carrier? Where can I get a fa carrier?
 

·
Premium Member
Joined
·
8,629 Posts
I have a 91 that I want to use my sear in. Is all I need to change the carrier? Where can I get a fa carrier?
Cheapest place will probably be RobertRTG.com. Do you have a hammer and some pin punches? You can get them really cheap if you're willing to get a bare one, you just have to move the locking lever and spring from your semi-carrier to the auto carrier.

And if you already have the sear in a pack that is on a HK93 or HK94, you'll also need to switch out the ejector lever. Each caliber uses a specific ejector lever. The tip of the 9mm one is only about 1/4" long, the back end of the lever is solid. The .223 one is the only one with 2 holes cut through the back end of the lever, and the .308 version has a tip that is 3/8" or so long.

Also, if it's currently in a 9mm pack, you'll likely need to change out the hammer spring as well.
 
1 - 2 of 2 Posts
Top