HKPRO Forums banner

1 - 8 of 8 Posts

Premium Member
Joined
690 Posts
Cool tool. I used a big ass screwdriver when I did mine. Might have to pick one up anyway.
 

Registered
Joined
388 Posts
I've tried all different screw drivers and I ended up damaging the guide rod bushing every time. Then a buddy (another member) showed me to use an EZ out which worked flawlessly, but left a little marring inside the bushing channel.

I'm picking up two of these for my buddy and I as it's just a tool that needed to be made!

HK doesn't even have tools at the service shop when you send in receivers. When you send one it and if they replace it, they usually damage it to the point it's unsalvageable and toss a new one in.

Great job @HK HAUS
 
1 - 8 of 8 Posts
Top